Subscribe to TIC

Posts tagged with “workshops”

From The Road: 21 Comments | Add a Comment

Dressing-up Roll-up Doors

by

I designed my new shop to look like an old horse barn, so it would blend in with the rural area of Southern Oregon where I now live. Being from Los Angeles, I went all the way with insulation and energy efficiency when I designed and built the shop. I even put in a radiant slab so my timid feet would stay warm in the cold, cold winters (it gets down in the low 20s here; sometimes even below 20 degrees!). So when it came to the 12-ft. wide x 9-ft. tall roll-up door, in order to get a good R-rating, I knew I had to use an insulated steel door. I found one rated at R-17, but it looked like something you’d see on a commercial building. Read the full article…

Hot Topics: 4 Comments | Add a Comment

Notice: A Day with Gary Striegler

by

So much was happening back in the first weeks of September 2001. Reading the news and watching videos of the Twin Towers, few of us knew that Roger Cliffe passed way, after suffering a heart attack while riding his bike. While some people knew him as Dr. Cliffe, because he taught technology classes at Northern Illinois University, many of us knew Roger as a prolific author of woodworking books (Table Saw Techniques, Radial Arm Saw Basics, The Shaper Handbook, etc. ), and as an extremely approachable woodworking instructor. Read the full article…

From The Road: 28 Comments | Add a Comment

My New Home: Choosing a Contractor

by

Early last winter, after searching for more than two years, I finally found a new home in Oregon, outside of Medford, near the small town of Ruch. It took a long time to find this place because I couldn’t decide where I wanted to live and once I did, I had a hard time finding a place I could afford—a small, older home that hadn’t been remodeled. After the “big boom,” houses like that became pretty rare. Read the full article…

From The Road: 25 Comments | Add a Comment

A Shop of My Own

by

Like a lot of guys I meet, I’ve spent years fighting to build cabinets and furniture, and mill custom moldings, in my garage shop—working around the 1951 Mack fire truck I restored, and the 1954 Harley I’m working on, and my newer bike—plus, I have to store all this crap for Gary and Mike’s Roadshows…well, you get the picture. I wanted a real shop, a place I could spread out and get some work done without having to move stuff every time I wanted to build something. Read the full article…