Subscribe to TIC

Posts tagged with “DeWalt”

Precision Lasers for Demanding Projects

DeWalt DW079LG vs. Stabila LAR120G

Installing trim packages in luxury custom homes today requires a stricter level of precision than ever before. When millwork is meticulously shop-drawn room by room and trim details flow between spaces, it’s crucial to have agreed-upon reference lines that are understood and trusted by multiple trades. Typically the General Contractor will set a benchmark, or horizontal axis line, at 48 or 60 in. AFF (above finish floor). Floor and ceiling planes are determined from this line, as well as door heads, horizontal trim elevations, and device heights. Grid lines may also be established on the floor to keep finish wall planes square and parallel. Collectively, all of these lines are referred to as axis lines, and serve as the three-dimensional starting point for locating finishes. Read the full article…

The DWS780: DeWalt’s New 12-in. Slider

As carpenters, we rely on our miter saws to help us do fast, accurate work. Our cut stations are the heart of our jobsite setups. It comes as no surprise that we expect a lot out of these tools—we are continually on the lookout for a saw that is precisely calibrated, feels natural, operates strong and smooth, offers large cutting capacity, and doesn’t weigh a ton. No single saw satisfies these criteria perfectly, and the new DWS780 is no exception. Read the full article…

Portable Table Saws: Bosch or Dewalt?

Most carpenters these days are very concerned about space. Whether we are trying to cram all of our tools into the back of a pickup, into a small garage/shop, or onto a cramped jobsite, most of us are all-too-aware that the old adage “bigger is better” is not always true. How many times have we been on a job only to wish we had brought that one tool that was left behind due to lack of space? Read the full article…

DeWalt DW 745 10-in. Portable Table Saw

A second portable table saw with a riving knife!

Ever since portable table saws first appeared on jobsites, carpenters have been throwing away the guards, and for good reason: They’re difficult to remove and re-install; after they’ve been used for a few months, you can’t see through the plastic shroud, so it’s impossible to align the blade with a measurement mark; you have to remove the guard to make narrow rips or rabbets; and carpenters have always suspected that the splitters cause more kickback than they prevent. Those are a lot of reasons to set aside a saw guard. Read the full article…

Miter Saw Tune-Up

If your miters aren’t as tight as they used to be, here’s how to get your saw singing on pitch again!

Every carpenter should know that when you buy a new chisel or hand plane it’s not razor sharp out of the box — you have to sharpen it before using it. Well, the same is true for miter saws. They don’t come from the factory in perfect tune.

Besides, after you’ve dragged your saw in and out of the truck a few dozen times, or jammed heavy stock against the fence, or maybe even had it flip off the back of a saw stand — or a tailgate — all those precise adjustments can get seriously out of whack. If you’ve noticed joints not quite closing up for you lately, it’s probably time to tune up your saw. Here are a few tricks to get that big investment dialed in just right. Read the full article…

DeWalt’s New Saw: The Inside Track!

Cregg Sweeney takes DeWalt’s new DWS520 for a spin.

www.dewalt.com :: List price $499

About 18 months ago I bought the Festool TS 55 track saw. I’ll admit that I was skeptical about all the buzz this tool was getting, but very interested to see how this saw performed. After doing everything from accurately ripping and crosscutting full sheets of plywood, to trimming new doors to fit old openings, to mitering maple butcher block countertops, ripping 45° bevels on cabinet face frames and end panels, and ripping long tapered extension jams, I have to say this saw met and exceeded my expectations. Read the full article…